ioLogik W5300
Click&Go Logic
4-5
Model
Number of Configurable
DIO Channels
Mode Settings
Digital Input
Digital Output
ioLogik
W5340-HSPA
8
ioLogik W5340
8
ioLogik W5312
4
When logged in as an administrator, double click on a channel in the
I/O Configuration
panel to configure
that channel’s settings. A window will open with configuration options for the channel. Each DIO channel will be
configured to act as either a DI or DO channel, according to the
Power On Settings
. To switch between DI and
DO channel operation, select the
desired mode in the
I/O Direction
field under
Power On Settings
.
After clicking
Apply
, you will need to
restart the ioLogik for the new
setting to take effect.
ATTENTION
Switching between DI and DO channel requires restarting the ioLogik for the new setting to take effect. You
must restart the ioLogik before proceeding with configuration or programming.
Digital Input Mode Selection
A DI channel can be set to
DI
or
Event Counter
mode. In DI mode, the channel connects to wet/dry contacts.
In Event Counter mode, the channel accepts limit or proximity switches and counts events according to the
ON/OFF status. When
Lo to Hi
is selected, the counter value increases when the attached switch is pushed.
When
Hi to Lo
is selected, the counter value increases when the switch is pushed and released.
Model
Number of Digital Input
Channels
Mode Settings
DI
Event Counter
ioLogik W5340-HSPA
8
ioLogik W5340
8
ioLogik W5312
8 DIs+4 DIOs
When logged in as administrator, double click on a
channel in the
I/O Configuration
panel to
configure that channel’s settings. A window will
open with configuration options for that channel.
Each DI channel will be configured to act as either
a DI or Event Counter channel, according to the
Mode Settings
. To switch between DI and Event
Counter channel operation, select the desired
mode under
Mode Settings.
ATTENTION
On this panel, be sure to select
Start
under
Counter mode parameter
on
Power On Settings
to activate
the Event Counter channel.