ioLogik W5300
Click&Go Logic
4-31
Do not use the reset button, since doing so will load all factory defaults and erase your rule-set from
memory.
3.
After the ioLogik has been restarted, the rule-set must be activated. Log in to ioAdmin as administrator, go
to the Click&Go Logic panel and click
Run
in the Rule-set Management bar. The rules in the rule-set will now
be active.
When the rule-set has been activated, it will remain active even when the ioLogik is disconnected from the host
computer or from the network. If the ioLogik is turned off, cellular I/O operations will resume when it is turned
back on, allowing you to use the ioLogik W5300 for PC-independent automation.
Rule-set Management Bar
When the rule-set has been activated from the Click&Go panel it will remain active even when the ioLogik is
disconnected from the host computer or from the network. If the ioLogik is turned off, cellular I/O operations
will resume when it is turned back on, allowing you to use the ioLogik W5300 for PC-independent automation.
•
Clear:
Erases the rule-set in both ioAdmin and the ioLogik W5300 series.
•
Retrieve:
Copies the rule-set from the ioLogik W5300 into ioAdmin.
•
Upload to ioLogik:
Copies the rule-set from ioAdmin to the ioLogik W5300.
•
Run:
Activates the rule-set that the ioLogik booted up with.
•
Stop:
De-activates the Click&Go rule-set and returns the ioLogik to normal, passive operation.
Import/Export Configuration
The ioLogik’s system configuration, including the current Click&Go rule-set, can be imported and exported. As
you make changes to a rule-set, you can export the system configuration in order to save that rule-set. Details
can be found in Chapter 2.
Log in as ioAdmin administrator from the
Server Settings
panel. You must log in as administrator to gain
access to the ioLogik’s configuration options. If a password has not been configured, simply click
Login
and
leave the
Password
entry field blank.
NOTE
Since there are major structural changes between firmware versions, configuration files generated by firmware
versions preceding V1.2 (included) for the ioLogik W5312 series, and firmware V1.4 (included) for the ioLogik
W5340 series, cannot be imported to the latest version of the firmware.