- 5 -
Installing the MC-3201
Wall Mounting
The MC-3201 can be installed on a wall by using the wall-mounting kit.
To install the MC-3201 on a wall, do the following:
STEP 1:
Use four screws for each bracket and attach the brackets to the
back of the MC-3201.
The screws are included in the wall-mounting kit. If you want to
buy the screws separately, use the following specifications:
Screw-M/FMS M4 x 6mm Ni/90D Nylok
STEP 2:
Use two screws per bracket to attach the MC-3201 to a wall or
cabinet.
Note:
Mounting the MC-3201 to a wall requires
four screws. Use the MC-3201 computer,
with the wall-mounting brackets
attached, as a guide to mark the correct
locations of the screws on the wall.
The heads of the screws should be at
least 6.0 mm in diameter, the shafts
should be 3.5 mm in diameter with a
minimum depth of 10 mm as shown in
the figure on the right. Do not drive the
screws in all the way; leave a space of
about 2 mm to allow room for sliding the
wall-mounting bracket between the wall
and the screws.
