MD-215 Hardware
Hardware Connection Description
3-3
Panel Mounting
The MD-215 Series comes with 8 optional clamp
mounts that allow for installation onto a wall (where
space has been cut out to accommodate the rest of
the hardware) or into computing stations where a
flush mount is desired. The maximum thickness
of the surface to which the display can be
clamped is 11 mm. For a secure mounting, all 8
clamps must be used. The clamp arms are fastened
into slots on all four sides of the MD-215. Use the
short M4 SUS (stainless) screws to fasten the clamp
arms to the MD-215 mounting slots, as shown in the
magnified inset in the diagram just below. Next, use
the clamps to fasten the display to its mounting
point; please note the torque values shown in the
figure inset below.
