- 12 -
Installing the SD Card
The UC-5100 Series computers come with a socket for storage
expansion that allows users to install an SD card.
Follow these steps to install the SD card:
1.
Unfasten the screw and remove
the panel cover.
The SD socket is located on the
front panel of the computer.
2.
Insert the SD card into the
socket. Ensure that the card is
inserted in the right direction.
3.
Replace the cover and fasten the
screw on the cover to secure the
cover.
To remove the SD card, simply push
the card in and release it.
Adjusting the CAN DIP Switch
The UC-5111 and UC-5112 computers come with one CAN DIP switch
for users to adjust the CAN termination resistor parameters. To set up
the DIP switch, do the following:
1.
Find the DIP switch location on the
top panel of the computer
2.
Adjust the setting as required. The
ON value is 120Ω, and the default
value is OFF.
Adjusting the Serial Port DIP Switch
The UC-5100 computers come with a DIP switch for users to adjust the
pull-up/pull-down resistors for the serial port parameters. The serial
port DIP switch is located on the bottom panel of the computer.
Adjust the setting as required. The ON setting corresponds to
1KΩ
and
the OFF setting corresponds to 150KΩ. The
default setting is OFF.
Each port consists of 4 pins; you must switch all 4 pins of a port
simultaneously to adjust the value of the port.
