UC-7400-LX Plus User’s Manual
Getting Started
2-18
Uploading and Running the “Hello” Program
Use the following command to upload
hello-release
to the UC-7400-LX Plus via FTP.
1.
From the PC, type:
#ftp 192.168.3.127
2.
Use the bin command to set the transfer mode to Binary mode, and then use the put command
to initiate the file transfer:
ftp> bin
ftp> put hello-release
3.
From the UC-7400-LX Plus, type:
# chmod +x hello-release
# ./hello-release
The word
Hello
will be printed on the screen.
root@Moxa:~# ./hello-release
Hello
Developing Your First Application
We use the tcps2 example to illustrate how to build an application. The procedure outlined in the
following subsections will show you how to build a TCP server program with serial port
communication that runs on the UC-7400-LX Plus.
Testing Environment
The tcps2 example demonstrates a simple application program that delivers transparent,
bi-directional data transmission between the UC-7400-LX Plus serial and Ethernet ports. As
illustrated in the following figure, the purpose of this application is to transfer data between PC 1
and the UC-7400-LX Plus through an RS-232 connection. At the remote site, data can be
transferred between the UC-7400-LX Plus’s Ethernet port and PC 2 over an Ethernet connection.
RS-232
LAN
PC 2
PC 1
Write data to PC1
Receive LAN data
Read serial data
Send data to PC2
tcps2.c
Serial Rx
Buffer
LAN Rx
Buffer
