Engine
SHOP MANUAL MT26-31 - 06.2005
Tier-3 710655-
Ch 1
page
109
Camshaft gear
Camshaft gear
Removing
1.
R emove the timing gear cover.
See Timing gear cover: Removing.
2.
R emove oil catcher from end of crankshaft.
3.
T urn the crankshaft so that the marks on the
camshaft gear and crankshaft gear point
towards the centre of the intermediate gear.
4.
R emove the intermediate gear.
5.
Pull off the camshaft gear using puller
587 315.
Note After the intermediate gear has been
removed, the camshaft and crank-
shaft must not be moved. Pistons
and valves could then strike each
other and sustain damage.
Fitting
1.
L ubricate the end of the camshaft using
engine oil.
2.
Heat the gear to 100 °C and drive it onto the
shaft with the marking facing outwards.
Make sure that the key is fitted in place.
3.
Fit the intermediate gear.
See Intermediate gear: F itting, points 1-2.
4.
Check that the gear has cooled down. Secure
the flywheel. T ighten the camshaft nut to a
torque of 600 Nm.
5.
Fit oil catcher on end of crankshaft.
6.
Fit the timing gear cover.
See Timing gear cover: F itting.
Summary of Contents for MT 26
