LITESPORT OWNERS MANUAL
Version 1.01
13
9.
The Litesport is equipped with a removable keel aft section. The glider can be left
resting on it, facilitating the fitment of the washout strut and battens. If desired, the
glider may now be raised onto its keel to complete the assembly. This also assists
with keeping the sail clean by keeping the tips off the ground.
Picture 10
Raising the glider onto the keel can make
assembly easier and keeps the sail clean.
10.
Gently insert battens 1-6, moving from the centre of the wing towards the mid span.
Use light force when inserting the battens, as this will greatly extend the longevity of
the batten pockets. Red tipped battens are for the left wing, green for the right, and
blue for the under surface.
11.
Open the zipper at the tip of the sail. Slide the fibreglass rod through the end of the
sail and into the end of the leading edge. Ensure that the rod is pushed hard against
its stop.
Picture 11
Insert the glass
wing tip
The glider may fall to one side if pushed or blown by the wind - this may result in
wing tip damage. It is recommended that you only use in flat level ground and in
nil wind. Use with care!
WARNING
!
Summary of Contents for LITESPORT 4
