LITESPORT OWNERS MANUAL
32
Version 1.01
MAINTENANCE SCHEDULE
Every l0 Hours
1.
Check all battens against the airfoil template.
2.
Sight through the sail zippers to inspect for any tube dents or bends.
Every 50 Hours (or biannually)
1.
Inspect the sail for wear and damage. Check the stress areas and apply sail repair
tape where necessary. Special attention should be directed to the wire slots.
2.
Inspect all batten flip tips.
3.
Inspect all cross bar wires, fittings, and hardware.
4.
Check all tubing for damage or wear caused by set up, pack up, or transportation.
5.
Inspect all rigging for frays and other signs of damage or deterioration. Replace if
necessary.
6.
Replace the lower side wires.
Every 100 Hours (or annually)
This inspection is best carried out by your local Moyes dealer or the Moyes factory. The
sail must be removed, allowing for all components to be exposed and thoroughly
examined.
Check the sail for any wear or abrasion. Small holes in low stress areas such as the
undersurface can be repaired with sail repair tape. Damage in higher stress areas such
as the trailing edge or centre seam need to be fixed by a professional sail maker. It is
best to contact your local dealer or consult Moyes directly about the repair of sail
damage.
Thoroughly inspect all tubing for dents, bends, and corrosion and replace when
necessary. All bolts should be examined closely for wear and bends. Remove all cross
bar junction bolts and the A-frame top bolt and closely examine for bends and corrosion.
Replace all parts that show damage.
Replace the top side wires every 100 hours.
Summary of Contents for LITESPORT 4
