LITESPORT OWNERS MANUAL
Version 1.01
33
SAIL REMOVAL
We suggest that you do not attempt to remove the sail if you are not familiar with this
procedure. Contact your nearest Moyes dealer for assistance.
1.
Lay the glider flat on the ground, unzip the glider bag, roll the glider over so that it is
top side up, remove all the ties, and spread the wings a few feet.
2.
Remove the sail attachment screws from the nose of the glider and rear of keel
pocket.
3.
Undo the central zipper entirely and remove the plastic cable tie at the nose of sail.
4.
Disconnect the luff line and undo the clevis pin on both sides to release the top side
wires from the leading edges.
5.
Disconnect the bottom side wires from the bottom of the down tubes by unscrewing
the hinge pin. Be sure not to lose any of the hardware during the process.
6.
Disconnect the rear wires from the keel by undoing the Bailey block bolt.
7.
Open the tip zippers and disconnect the sail attachment straps from the clevis pins
at the end of each leading edge.
8.
Carefully slide the frame forward and out of the sail.
To re-mount the sail, reverse the process by which it was removed.
All Velcro straps attaching the top and bottom surfaces must be overlapped their full
length.
Summary of Contents for LITESPORT 4
