12
6. Installation
All
MP SYSTEMS
Purge Series are shipped on wooden pallets designed for the safe
transport of the Purge Series Full Flow Filtration System. A large
MP SYSTEMS
box
protects the Purge from any unnecessary damage during transportation. If there is
visible damage from transportation, refer to
Section 5.1 Delivery Checks
.
•
Typical installation time required: 4 Hours
•
Plumbing kit includes inlet, and return dip tubes, hoses, and clamps.
•
3 Phase power kit w/circuit breaker provided to pull power directly from machine.
•
Purge can be set to automatically run when powered on; or with scheduled timer.
•
Status indicator light and HMI removes need for alarm interface with machine.
•
May require hole saws, see appendix in back for more information.
•
The Purge
requires roughly 24” x 24” of floor space that is located as close to the
machine tank’s coolant pump(s) as possible to allow for proper return flow.
•
The feed pump can be mounted remotely and should be located close to the inlet
suction dip tube.
•
The pump can either sit directly on the floor or be mounted on the coolant tank if
space allows.
•
Purge Electrical panel and Manifold locations can be swapped if required for
proper return hose direction.
Summary of Contents for PURGE Series
