89
Preface
previously set password from CMOS memory. You may also
press
[ESC]
to abort the selection and not enter a password.
When the Supervisor Password is set, the new item
User Access Level
and
Password Check
will be added in the menu. You can make further
settings of access right in the
User Access Level
item. Setting options:
No Access
,
View Only
,
Limited
, and
Full Access
. The Password
Check item is used to specify the type of BIOS password protection that
is implemented. Settings are described below:
To clear a set password, just press
[Enter]
when you are prompted
to enter the password. A message box will show up confirming the
password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup without entering any
password.
Supervisor Password allows the user to enter and change the
settings of the setup menu; User Password only allows the user to
enter the setup menu, but not to make changes.
Summary of Contents for TransPort U1100
