MAXX
PRODUCTS INTERNATIONAL, INC.
815 OAKWOOD RD, UNIT D, LAKE ZURICH, IL 60047, USA
Phone: (847)438-2233 Fax: (847)438-2898 Website: www.maxxprod.com
REV: , 9/10/07
Himax Brushless motors are manufactured to high standards for the discerning modeler. Designed for light-weight, high
efficiency, high torque, and durability Himax Outrunner motors are sure to make today’s radio controlled models perform.
Please read the entire operating manual to ensure correct functionality and best performance. The HC2805-1430 series
motor is made for small models weighing 7 to 14 ounces.
Features:
High Efficiency - High Power - High Torque - Light-weight - Replacement for 370-400 Motors
Specifications:
Weight: 27g, (0.95oz)
Max Power: 70W, (This is dependent on several factors)
Max RPM: 20,000 RPM
Diameter: 28mm, (1.10”)
Length: 26mm, (1.02”)
Shaft Diameter: N/A, built-in prop-saver and two adapter rings to fit props with 6, 7, 8 mm mounting holes
Mounting Holes: Four 2.5mm threaded holes, max depth 2.5mm, on 16mm, (.625”) bolt circle
Four 2mm through holes, on 31mm, (1.22”) bolt circle
Maximum Case Temperature: 65
o
C, (149
o
F)
Electrical Specifications:
HC2808-1430 Kv = 1430, Rm = .245, Io = 0.6, Efficient Operating Current = 4 - 8.5 A, 11A Max 15 seconds
Operation:
1.
Himax Brushless motors require brushless sensorless speed controls.
Failure to use a brushless sensorless elec-
tronic speed control (ESC) can result in damage to the motor and/or ESC. A Castle Creations Phoenix or Thunderbird
series ESC is recommended for best performance. The standard setting for timing advance is recommended for best
operation.
2.
The three wires of the motor can be connected to the three output leads of the ESC in any order. Check the direction of
rotation of the motor. If the motor spins in the wrong direction switching any
two
of the motor wires will reverse rotation. Be
sure to insulate the wires to prevent shorting which may damage the ESC.
3.
If the supplied connectors are not to be used, remove them by desoldering.
DO NOT CUT THE CONNECTORS OFF
!
4.
Allow for proper cooling of the motor during operation. With extremely high capacity batteries, care must be taken to
prevent excessive motor temperature. Overheating of the motor is not covered under warranty. Insufficient cooling can
result in overheated motors, even when operated at moderate power levels.
5.
Do not disassemble the motor. Disassembling the motor voids the warranty. If service is required please return the unit
to Maxx Products for service.
6.
Install the propeller after proper rotation has been determined. Consult the ESC operation manual for proper arming and
use procedures. Be sure the prop is clear before starting the motor. Once the battery is plugged in stay clear of the prop,
electric motors are capable of extremely high torque and can be very dangerous.
Himax
Himax
Himax
Himax
Himax
Brushless Outrunner Motor
HC2805-1430
Outrunner Motor
