196
6
Restore The Printer To Operation
E06 NOT ALIGNED
See User Manual
Yes
An illegal or
unsupported instruction
was attempted in the
application program.
1.
Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2.
Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
E07 ILLEGAL INS
See User Manual
Yes
An illegal or
unsupported instruction
was attempted in the
application program.
1.
Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2.
Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
E08 FLOATINGPNT
See User Manual
Yes
An illegal or
unsupported instruction
was attempted in the
application program.
1.
Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2.
Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
EC SOFTWARE FAIL
Cycle Power
Yes/No
Engine control software
failure.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution