Fault Messages
207
RFID TAG FAILURE
Check Media
Yes
Failed tag. Error
displays in STOP
mode, causing the
printer to halt.
Initiate reprint of the label
from the host. When the
error is cleared, the label
with the failed tag moves
forward to the next TOF
position.
RFID TAG MAX
RETRY
Check Media
Yes
Failed tag. Error
displays in
OVERSTRIKE mode.
Each failed label prints
with the OVERSTRIKE
pattern; the form retries
until the label retry
count is exhausted.
Clear the error. When the
error is cleared, the label
with the failed tag moves
forward such that the next
label is in position.
Ribbon Low
Yes
1.
The supply spool is
getting low.
2.
If there is a large
amount of ribbon
still on the supply
spool, then the
Ribbon Low
message is being
displayed falsely.
1.
Replace ribbon.
2.
Disable Ribbon Low in
the MEDIA SETUP
menu.
RIBBON OUT
Load Ribbon
Yes
1.
The ribbon supply
spool is empty.
2.
The ribbon has
broken.
1.
Replace the ribbon.
2.
Reinstall the ribbon.
SECURITY CODE
VIOLATION
Yes
The software being
used is not correct for
the printer.
1.
Load the correct
software.
2.
Power off the printer for
15 seconds, then power
back on again. If the
problem persists,
contact your authorized
customer service
representative.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution
