EMULATION Submenus
103
Var Form Adjust
This specifies an amount (in tenths of inches) to add to the length of variable-
length forms. Variable-length forms use a semicolon at the end of the
CREATE command: ~CREATE;<FORMNAME>;0.
Var Form Type
•
Add Nothing
(factory default). When selected, no action is taken.
•
Add ;0
. When selected, the form length ends at the longest printed
element. (Same as
∼
CREATE;filename;0)
•
Add ;X
. When selected, the form length is the same as the physical page
length (the Label Length menu under MEDIA SETUP). (Same as
∼
CREATE;filename;X).
Optimized Ratio
This option selects different bar code ratios for certain bar codes including
Code 39 and Interleaved 2 of 5. It is included for compatibility with the
IGP-X00 printers.
•
Disable
(factory default). Use standard bar code ratios.
•
Enable
. Select the alternate bar code ratios.
PI Slew Range
You can specify how many lines the paper will feed.
•
16
(factory default). A paper slew of 0-15 will move 1-16 lines.
•
15
. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will move
1 line.
CR Edit
This parameter determines if a carriage return will be followed by a line feed.
•
Disable
(factory default). The printer ignores all carriage returns that are
not followed by line feeds.
•
Enable
. The printer processes all carriage returns, even for those that are
not followed by line feeds.
Skip Cmd Prefix
Stands for Skip Command Prefix. This parameter determines if the printer will
print any data before a PGL command is received.
Ignore Text
•
Disable
(factory default). When disabled, text in normal mode will be
printed. Attributes to be printed depend on the PGL Normal menu setting.
•
Enable
. When enabled, any line of text (non-PGL commands) in normal
mode will be ignored.
