200
6
Restore The Printer To Operation
FILE SYS WRITE
Check Flash
Yes/No
Problem writing to flash
memory.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
GAP NOT DETECTED
Check Sensor and
Calibrate
Yes
The printer is set for
Gap or Mark sensing,
but no gap or mark was
detected.
1.
Check that the setting of
the Gap/Mark Sensor in
the SENSOR SETUP
menu matches the
installed media.
2.
Check the position of the
media sensors. (See
“Positioning The Media
Sensors” on page 47.)
3.
Clean the sensor
assembly and paper
path.
4.
Run Auto-Cal to improve
the sensor’s ability to
detect the media in use.
5.
Run the Media Profile
printout in the SENSOR
SETUP menu.
6.
Run Manual Calibrate.
(See “Running Manual
Calibrate” on page 53.)
7.
Manually change the
Gap/Mark Thresh and/or
Paper Out Thresh
values.
H00: PCI SLOT?
See User Manual
No
The controller board is
not communicating with
a PCI card. This could
indicate a bad PCI card,
poor connection, or
problem in the PCI bus.
Contact your authorized
service representative.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution
