Load Media
247
Load Media
Figure 37. This Illustration Shows Ribbon and Media Loading for Standard Peel Operation
1.
To load media, refer to “Loading Roll Media” on page 27 and complete
steps 1 through 7.
2.
Open the standard peel door by pulling it out and down.
3.
Thread the media over the peel bar, behind the standard peel roller, and
through the standard peel opening (see Figure 37).
4.
Horizontally center the standard peel roller over the label.
5.
Peel the label (located over the tear bar) off the liner (refer to Figure 37).
This will prevent the labels from sticking to the tear bar during the initial
print feed.
Media Cover
Media Damper
Media Width
Guide
Standard Peel
Door
Standard Peel Roller
Label
Peel Bar
Deck Lock
Lever
Pivoting
Deck
Standard Peel
Opening
NOTE:
Peel
shaded label
off liner.
