252
Appendix B
Using The Full Media Rewinder Option
Rewinder Full Sensor Setup
1.
Open the side cover and media cover.
2.
Position the rewinder full sensor in the lower position and tighten the
thumbscrew. See Figure 40.
NOTE:
When the rewinder full sensor detects a roll full condition, the
rewinder beeps and the message “REWINDER FULL Remove Roll”
displays.
3.
Close the side cover and media cover.
Remove Printed Media from the Rewinder
1.
Open the media cover and side cover.
2.
Press the
(Feed) key to advance the last printed label past the
printhead, and tear the liner from behind the last printed label.
3.
Manually rewind the remaining printed labels onto the rewinder by turning
the rewinder.
4.
Pull the media rewinder clip (along with the printed labels) off the
rewinder.
5.
Remove the printed labels from the media rewinder clip. Set the printed
labels aside.
6.
Insert the media rewinder clip into the rewinder.
7.
Close the side cover and media cover.
