32
2
Setting Up The Printer
Loading Fanfold Media
Figure 12. This Illustration Shows the Loading of Fanfold Media
1.
Open the media cover.
2.
Slide the media hanger guide outward to the end of the media hanger.
3.
Place the fanfold media either behind or beneath the printer, depending
on the desired fanfold supply location. Insert the first few labels through
either the rear or bottom panel opening.
4.
Place the media over the media hanger, flush against the back of the
printer.
5.
Slide the media hanger guide against the outer edge of the fanfold media
to prevent horizontal travel.
6.
Open the pivoting deck by rotating the deck lock lever fully
counterclockwise until the deck and printhead swing upward.
Media
Hanger Guide
Fanfold
Media
Media Hanger
Deck Lock
Lever
Pivoting Deck
Media Cover
Bottom Panel
Opening
Media Damper