MEDIA SETUP Submenus
83
Label Missing
If enabled, causes the Label Taken Sensor to first check for the presence of a
printed label at the tear bar for Peel Off and Tear Off Media Media Handling
Modes only.
•
Fault Disable
(factory default). The printer does not generate a fault
condition if a missing label is encountered. The printer will continue
printing the next label.
•
Fault Enable
. The printer generates a fault condition if a missing label is
encountered.
Clip Page
This option determines how the printer handles images that are too large for
one physical page length when using gap or black mark media.
•
Enable
(factory default). When the user-selected page length is greater
than the physical page length, the printer clips the excess data to fit the
physical page. The excess data is lost. The media sensor constantly
looks for the gap, notch, hole, or black mark and when detected, uses it
as the Top-of-Form position for the next label and clips any remaining
data from the label being printed.
•
Disable
. When the user-selected page length (logical length) is greater
than the physical page length dictated by the gap, notch, hole, or black
mark on media, the printer continues to print the remaining excess data
onto the next physical page.
The media sensor looks for the gap, notch, hole, or black mark only after
the media has advanced the distance specified by the Label Length value
in the MEDIA SETUP menu or by the Host Forms Length value sent via
the software. Any gaps, notches, holes, or black marks that exist prior to
reaching the Label Length or Host Forms Length value are ignored.
When Clip Page is set to Disable, Mark and Gap media sensing reliability
can be improved and the sensor problems described below can be fixed:
•
The image starts to print at an erroneous distance from the top-of-
form, especially towards the end of a roll where the media is severely
curled or scalloped.
•
The image is incorrectly positioned as a result of the media sensor
triggering off of a dark, pre-printed image on the label or multiple gaps
within the label.
•
The printer starts to print one label and then another all on the same
physical label, especially at the end of a roll where the media is
severely curled.
•
An occasional blank label appears within a print job (in between
printed labels).
When Clip Page is set to Disable, the printer ignores any pre-printed dark
marks or multiple gaps on a label that could mistakenly be detected as
the next top-of-form position based on the specified Label Length value.
The Label Length option is in the MEDIA SETUP menu.