Use Instructions
(MAN-0013-A)
Page 17 of 47
DCR-00422
Hand Control Functions
Hand control functions vary depending on the model purchased, your hand control may
not include all functions shown.
The control system will limit the product’s motion for certain models. This is done to
prevent unwanted contact between support surface and the base frame. The control
box will emit a “beep” sound when the motion is limited.
If a beep sounds, adjusting
the Trendelenburg or extending the calf section closer to level will allow for additional
motion.
For the product to reach the lowest chair position, the seat section must be level or in a
Trendelenburg position. Level position may be achieved using the Trendelenburg
function on the hand control. The product will pause motion when a level position is
achieved.
Surface Height Adjustment
The
surface height may be adjusted between 24” and 3
8
”
.
Press and hold the applicable hand control
function to adjust the seat height.
Fowler Adjustment
The Fowler section may be adjusted between 0° and 90°.
Press and hold the applicable hand control
function to independently adjust the
Fowler.
Calf Adjustment
The calf section may be adjusted between 0° and 88°.
Press and hold the applicable hand control
function to independently adjust the
Trendelenburg angle.
