MPM MOP-22M, User Manual

11

GB

the mains. Leave it running for 10 minutes. Next, unplug the toaster from the mains and wait 
until it cools down completely. The hot plates may smoke slightly during this process. This is 
natural and will no recur during further use. 

NOTE! Bread may burn! Therefore the appliance must not be used near or below curtains and in vicinity of other 
combustible materials!

NOTE! The working surfaces of the roaster are heated up to extremely high temperatures! Touch the holders 
only!

USE OF THE ROASTER

NOTE! When opening the cover, proceed carefully owing to hot damp from the area under the heating panels! 

1. 

Oil the heating plates 

❺

 with butter, margarine or other fat.

2. 

Insert the plug into the power outlet. The red light 

❶

 will go on to signal power. Close the 

cover of the appliance 

❸

.   

3. 

Prepare the sandwiches.

4. 

When the green indicator lamp 

❷

 will turn on, open the cover by pulling the latch 

❷

 and 

put the sandwiches on the heating panels. Gently close the cover and clamp with clip 

❷

.

5. 

When checking the condition of sandwiches in course of their roasting, open the cover care-
fully owing to hot damp escaping from the both sides of the roaster!

6. 

Open the cover and remove roasted sandwiches using wooden or plastic spatula.

7. 

Before preparation of the next sandwiches, always close the cover in order to maintain re-
quired temperature. The green caution lamp (thermostat) will go on and off in course of 
roasting to indicate that required temperature is maintained.

8. 

After finished roasting pull out the plug from the plug socket and allow the appliance to cool 
completely.

NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces are possible! 

CLEANING AND MAINTENANCE

1. 

Prior to commencing the cleaning (and after finishing the roasting), pull out the plug from 
the plug socket and allow the appliance to cool completely.

2. 

Thoroughly wipe the heating panels, clean the roaster edges using soft cloth or towel.

3. 

If complete removal of any food residuals from the surface of heating panels is problematic, 
pour some edible onto dirty surface and try to clean after about 5 minutes. Your efforts will 
be successful this time.

4. 

Wipe the external surface of the roaster using wet cloth.

ATTENTION! Do not immerse the appliance in water or any other liquids! Do not wipe the inside of the appliance 
with acute, abrasive cloths or sponges, as this can damage the heating surfaces!