31
GB
DEFROSTING OF THE FREEZER
The freezer compartment, however, will become progressively covered with frost. This should
be removed. Never use sharp metal tools to scrape off frost from the evaporator as you could
damage it. However, when the ice becomes very thick on the inner liner, complete defrosting
should be carried out as fellows:
– Unplug the unit. Remove the drain plug from the inside of the freezer. Defrosting usually
takes a few hours. To defrost faster keep the freezer door open.
– For draining, place a tray beneath the outer drain plug. Pull out the drain dial.
– Rotate the drain dial 180 degree. This will let the water flow out in the tray.
When done, push the drain dial in. Replug the drain plug inside the freezer
compartment.
Note:
monitor the container under the drain to avoid overflow.
– Wipe the interior of the freezer and replace the electrical plug in the electrical
outlet.
– Reset the temperature control to the desired setting.
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent
person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance dose not work.
Mains plug is not plugged in or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Socket is defective.
Mains malfunctions are to be corrected by an electrician.
Appliance freezes too much.
Temperature is set too cold or the appliance runs at
MAX setting.
Turn the temperature regulator to a warmer setting
temporarily.
The food is not frozen enough.
Temperature is not properly adjusted.
Please look in the initial Temperature Setting section.
Door was open for an extended period.
Open the door only as long as necessary.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
Turn the temperature regulation to a colder setting
temporarily.
The appliance is near a heat source.
Please look in the installation location section.
Heavy build-up of frost on the door
seal.
Door seal is not air-tight.
Carefully warm the leaking sections of the door seal with
a hair dryer (on a cool setting). At the same time shape
the warmed door seal by hand such that it sits correctly.
Unusual noises.
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear of the appliance
is touching another part of the appliance or the wall.
If necessary, carefully bend the component out of the
way.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Otwór
Otwór
