MPM MPM-206-SK-06E, User Manual

20

GB

DEFROSTING OF THE FREEZER

The freezer compartment, however, will become progressively covered with frost. This should 
be removed. Never use sharp metal tools to scrape off frost from the evaporator as you could 
damage it. However, when the ice becomes very thick on the inner liner, complete defrosting 
should be carried out as fellows:

– Unplug the unit. Remove the drain plug from the inside of the freezer. Defrosting usually 

takes a few hours. To defrost faster keep the freezer door open.

– For draining, place a tray beneath the outer drain plug. Pull out the drain dial. 

– Rotate the drain dial 180 degree. This will let the water flow out in the tray. 

When done, push the drain dial in. Replug the drain plug inside the freezer 
compartment. 

Note:

 monitor the container under the drain to avoid overflow.

– Wipe the interior of the freezer and replace the electrical plug in the electrical 

outlet.

– Reset the temperature control to the desired setting. 

Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent 
person must do the troubleshooting that is not in this manual.

Important! There are some sounds during normal use (compressor, refrigerant circulation).

Problem

Possible cause

Solution

Appliance dose not work. 

Mains plug is not plugged in or is loose.

Insert mains plug.

Fuse has blown or is defective.

Check fuse, replace if necessary.

Socket is defective.

Mains malfunctions are to be corrected by an electrician.

Appliance freezes too much. 

Temperature is set too cold or the appliance runs at 

MAX setting. 

Turn the temperature regulator to a warmer setting 

temporarily.

The food is not frozen enough. 

Temperature is not properly adjusted.

Please look in the initial Temperature Setting section.

Door was open for an extended period.

Open the door only as long as necessary.

A large quantity of warm food was placed in the 

appliance within the last 24 hours.

Turn the temperature regulation to a colder setting 

temporarily.

The appliance is near a heat source.

Please look in the installation location section.

Heavy build-up of frost on the door 

seal.

Door seal is not air-tight.

Carefully warm the leaking sections of the door seal with 

a hair dryer (on a cool setting). At the same time shape 

the warmed door seal by hand such that it sits correctly. 

Unusual noises.

Appliance is not level.

Re-adjust the feet.

The appliance is touching the wall or other objects.

Move the appliance slightly.

A component, e.g. a pipe, on the rear of the appliance 

is touching another part of the appliance or the wall.

If necessary, carefully bend the component out of the 

way.

If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, 
refer to the rating plate.

Otwór

Otwór