21
GB
7. CLEANING AND MAINTENANCE
WARNING!
Always disconnect the device from the mains before you clean and service it.
NOTICE! Risk of damage
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during cleaning as these
can damage the cooler.
h
Occasionally clean the device interior and exterior with a damp cloth.
h
Make sure that the air inlet and outlet vents on the device are free of any dust and dirt, so
that heat can be released and the device is not damaged.
8. TROUBLESHOOTING
Problem
Possible cause
Suggested remedy
Your device is not working
(plug is inserted).
There is no voltage flowing
from the DC socket (cigarette
lighter) in your vehicle.
The ignition must be switched on in most
vehicles to supply current to the cigarette
lighter.
No voltage present in the
AC voltage socket.
Try using another plug socket.
The inner fan or the cooling
element is defective.
This can only be repaired by an authorised
repair centre.
When operating from the
DC socket (cigarette lighter):
The ignition is on and the cooler
is not working.
The fitting of the DC plug is dirty.
This results in a poor electrical
contact.
If the plug of your cooler becomes very
warm in the DC socket fitting, either
the fitting must be cleaned or the plug
has not been assembled correctly.
The fuse of the DC plug has blown.
Replace the fuse of the DC plug with
one of the same rating.
The vehicle fuse has blown.
Replace the vehicle’s DC socket fuse (usually
15 A). Please refer to the operating manual
of your vehicle.
Summary of Contents for MPM-34-CBM-06
Page 23: ......
