MPM MZE-15, User Manual

CAUTION! Do not overfill the water tank above the MAX level. Always use fresh demineralised/distilled water 
for best ironing performance. Never use chemically decalcified water or any other liquids.

5. 

Close the water fill lid 

11

.

USING THE APPLIANCE

TEMPERATURE SETTING

1. 

Plug the power cord 

6

 to a PE mains outlet. 

2. 

Put the iron standing up and set the required ironing temperature by turning the tempera-
ture control knob 

5

 to the desired position.

TEMP KNOB POSITION

THERMOSTAT ADJUSTMENT

TEXTILE TYPE

•

Low temperature

Synthetic fibres

• •

Moderate temperature

Silk / wool

• • •   /   M a x

High temperature

Cotton / linen

CAUTION! Check the required ironing temperature of your textile product by referring to its information tab. 
If you are unsure what fabric type the product to be ironed is, find the correct temperature setting by ironing 
the part of the product that will be concealed when in use/worn. Start from the lowest temperature setting 
and increase it gradually. Silk, cotton and synthetics: to prevent glossy spots from heat, iron these materials 
inside out and covered with another thin fabric. Do not use the spray jet to avoid stains while ironing. Velvet 
and similar materials must be ironed in one direction only. Do not hold the iron in one spot, make full passes. 
Iron synthetics and silk inside out and without steam.

CAUTION! Always start ironing with the products that require the lowest temperature setting.

3. 

The indicator 

7

 will turn on. 

4. 

When the indicator 

7

 turns off, wait a few seconds and start ironing. The indicator 

7

 turns 

on and off during ironing. When the indicator is off, the iron has reached the preset tempera-
ture and you may iron.

5. 

If the iron is set to high temperature from the start and then switched to a lower one, contin-
ue ironing when the indicator 

7

 is on again. This will protect the textile from burn damage.

STEAM IRONING

1. 

Make sure that the water tank 

8

 has enough water.

2. 

Set the recommended temperature (see TEMPERATURE SETTING).

3. 

Set the correct steam output 

with the control slider 

1

.

CAUTION! Steam ironing is only possible at higher temperatures (the temperature range is shown on the 
<<STEAM>> adjustment knob).

CAUTION! When the iron reaches the preset temperature, it will begin steaming. The appliance generates very 
hot steam!

13

GB