MPMan EB9, User Manual

9

10

EN

EN

5.Bearings

-Ensure all bearings are lubricated, run freely and display no excess movement, grinding or ratting.
-Check headset, wheel bearings, pedal bearings and bottom bracket bearings.

6.Cranks and Pedals

-Ensure pedals are securely tightened to the cranks.
-Ensure cranks are securely tightened to the axle and are not bent.

7.Derailleurs

-Check that front and rear mechanisms adjusted and function properly.
-Ensure shift and brake levers are attached to the handlebar, shift and brake.
-Ensure derailleur, shift levers and shift and brake cables are properly lubricated.

8.Frame and Fork

-Check that the frame and fork are not bent or broken.
-Either if are bent or broken, they should be replaced.

9.Accessories

-Ensure that all reflectors are properly fitted and not obscured.
-Ensure all other fittings on the bike are properly and securely fastened, and functioning.
-Ensure the rider is wearing a helmet.

10.Motor Drive Assembly and Throttle

-Ensure all motor drive components are correctly mounted and functioning properly.

11.Battery Pack

-Ensure the batteries are in good operation condition and kept fully charged.

Battery Care and information

Proper maintenance of batteries will maximize their lifespan and capacity. The warranty of your new battery is from the date of purchase 
only if properly cared for- refer to the limited warranty for details.
We use Li-lon(Lithium lon)batteries in all of our electric bicycles and scooters.
These are both very use-friendly types of batteries when cards for properly.

Care

Even with proper care, rechargeable batteries do not last forever. Every time the battery is discharged and subsequently recharged, 
its relative capacity decreased by a small percentage. You can maximize the life of your battery by following the instructions in this guide.
-Batteries should be fully charged immediately when they are received for the full recommended charge times: 
 

Li-lon recommended charge time:

4-6 hours for a complete, 100% charge, leave the battery on the charger for one full hour after 

 the charge indicator light turns green.
-Never charge batteries for longer than 24 hours.
-Li-Lon batteries do not have a “memory”. Partial discharge/charge cycles will not harm the batteries’ capacity or performance.
-The rated output capacity of a battery is measured at 77°(25°C)

.

Any variation in this temperature will alter the performance of the battery, 

  and shorten its expected life. High temperatures especially reduce overall battery life & run time.
-Our bikes and scooters are equipped with a five-minutes sleep function. If no activity is detected after five minutes, the bike /scooter will 
  go into “stasis” mode to conserve battery power. Simply cycle the bike/scooter off then on again to re-activate the battery.
-Always be sure to turn the bike/scooter power switch to “OFF” after each use. If you leave the power switch in the “ON” position, 
  or your product has not been charged for a long period of time, the batteries may reach a stage at which they will no longer hold a charge.
-Be friendly to the environment! Be sure to recycle at a local battery-recycling center. Do not throw them in the garbage! 
 Check www.call2recycle.org for more information on free battery drop off locations.