Getting Started
Charging the Player
The player comes with a built-in rechargeable lithium-polymer battery.
Charge the battery fully before using it for the first time. If the player has not been used in a while, the battery may need to be recharged
overnight (about 8 hours).
To charge the battery:
1. Plug the small end of the included USB cable into the player’s USB connector.
2. Plug the large end of the USB cable into a computer’s USB 2.0 Hi-speed port. The LCD screen will turn on and display the message USB
connecting.
a. The computer must be turned on, and;
b. The USB port must be a high-power port. High-power ports can usually be found on the main computer unit.
3. Disconnect the player when it is fully charged.
The computer must be powered on and not in sleep mode in order to charge the battery.
The player will not charge if it is connected to a low-power USB port. Low-power ports may be found on a peripheral device that is
connected to the computer (e.g., a keyboard).
If the player is connected to the computer through a USB hub, the hub must be self-powered to charge the battery.
TIP
You can press and hold [ESCAPE] after the player is connected to cancel the data connection and switch to USB power mode.
This will allow you to use the player normally while drawing power from the computer.
The battery used in this device may present a fire or chemical burn if mistreated. Do not disassemble, incinerate, or heat the
battery. Do not leave the battery in a place subject to direct sunlight, or in a car with its windows closed. Do not connect the player
to a power source other than that which is indicated here or on the label as this may result in the risk of fire or electric shock.
Turning the Player On/Off
To turn the player on, press and hold the <POWER> button until the screen turns on.
To turn the player off, press and hold the <POWER> button until the screen turns off.
If the player stops responding or otherwise behaves abnormally, press and hold [POWER] for several seconds to turn it off. Wait a
