mSquad User’s Guide
13
5.
Configuration Mode
The Configuration Mode (Config Mode) is used to adjust the POLI’s operation settings and
calibrate sensors. For mSquads, this mode is additionally used to select the wireless channel,
register devices, and assign worker names. See the POLI User’s Guide for instructions on how to
enter, navigate, and exit Configuration Mode. Only configurations relevant to wireless operations
are described here.
5.1 Navigating Configuration Mode to Edit Parameters
After entering Config Mode, the calibration menu is displayed first. Press [ /↓]
(
→
)
to step
through the menus and [+/OK] (Enter) to enter a menu to edit the parameters in its submenu.
5.1.1
Configuration Mode Menus and Sub-menus
Calibration
Measurement
Alarm
Datalog
Monitor Setup
Wireless**
Exit
Fresh Air Calib
Enable/Disable High Limit
Clear All
LCD Contrast
Register Devices
Nitrogen Calib
PID Meas. Gas Low Limit
Interval
Pump Speed*
Assign Worker
¥
Span Calib
Set Custom CF
(for PID only)
STEL Limit
Sensor Select Pump Stall*
Register
Bump Test
Gas Unit
TWA Limit
Exit
Temp. Unit
Host ID
Span Value
Exit
Alarm Device
Language
Channel
Exit
Heart Beat Light
Back Light Mode
Exit
M-D
†
On/Off
LCD Auto Flip
M-D
†
Warn Time
Policy Check
M-D
†
Threshhold
Real-Time Clock
M-D
†
Tmotionless
3-Point Cal.
Exit
Exit
* Operational in Pump versions only ** Operational in Wireless versions only
†
M-D = Man-Down
¥
Host only
