UNI MP100 User’s Guide
11
and
if enabled, or between
and
if disabled. Use the Right Key
to change the status, and the Left Key to confirm and exit. When the unit is re-started and user
is prompted with
to zero, it must be initiated within 30 s or else the zeroing is skipped.
4.6.7
Fast Power-on Enable/Disable
If fast startup is enabled, the screens showing HIGH/LOW/STEL/TWA alarm threshold values
will be skipped during warm up sequence. On start-up, the unit shows the firmware version
number and then goes directly to concentration readings.
The fast power-on menu alternates between
and
. Press the
Left Key
to change
the fast startup enable/disable status. Enable or disable Fast Power-on and confirm the status
using the same process as for Vibration Alarm or Power-on Zero enable/disable.
4.6.8
Configuration Reset
If some unit parameters are incorrect and the user has difficulty correcting them, this menu can
be used to set the all the configuration parameters back to the factory default condition. From the
alternating
and
display, press the Left Key to enter the
(reset) menu.
Then press the Left Key
to confirm or the Right Key to abort the reset.
