MT76D RAMMER • OPERATION AND PARTS MANUAL — REV. #7 (07/14/16) — PAGE 17
MAINTENANCE
DAILY
Thoroughly remove dirt and oil from the engine and
control area.
Clean or replace the air cleaner elements as necessary.
Check and retighten all fasteners as necessary.
Check the spring box and bellows for oil leaks. Repair
or replace as needed.
FUEL FILTER (EVERY 50 HOURS)
1. Remove fuel hose from outlet port on fuel filter. Drain
fuel into a suitable container.
2. Remove fuel filter mounting hardware (Figure 11) from
the fuel tank.
Figure 11. Removing Fuel Filter
3. Next, remove fuel filter from fuel tank (Figure 11).
4. Remove the fuel tank cap and inspect for dirt inside
the fuel tank. If dirty, clean fuel tank.
5. Replace fuel filter and o-ring.
6. Reinstall fuel filter and o-ring back into fuel tank. Secure
fuel filter with mounting hardware.
7. Reconnect fuel hose to fuel filter outlet port.
NOTICE
Replace fuel lines every 2 years even if there is no
visible damage.
FUEL STRAINER (EVERY 50 HOURS)
1. Thoroughly clean the area around the fuel cap.
2. Remove the fuel cap from the fuel tank.
3. Next, remove, inspect and clean the fuel strainer
(Figure 12) with solvent.
Figure 12. Fuel Strainer Removal
4. Reinstall fuel strainer and fuel cap.
REPLACEMENT OIL BATH LUBRICANT
1. Remove the drain plug at the rear of tamper foot and
drain the dirty oil. Refill with clean oil to the middle of
the sight glass.
Figure 13. Draining Oil Bath Lubricant
2. Remove the oil drain plug on foot housing (Figure 13)
and drain the oil. Refill with approximately 0.85 qt. (0.80
litesr) of 10W-30 SE, SF or higher grade motor oil. Oil
should be midway in sight glass.
Break in oil
should
be changed after first
50 hours
of operation.
3. Second oil change and/or later, every 200 hours of
operation.
Summary of Contents for Mikasa MT76D
