DCA300SSJU4F2 60 HZ GENERATOR• OPERATION MANUAL — REV. #0 (06/26/18) — PAGE 33
GENERATOR OUTPUTS/GAUGE READING
HOW TO READ THE AC AMMETER AND AC
VOLTAGE GAUGES
The AC ammeter and AC voltmeter gauges are controlled
by the AC ammeter and AC voltmeter change-over switches.
Both of these switches are located on the control panel and
DO NOT
effect the generator output. They are provided to
help observe how much power is being supplied, produced
at the UVWO terminals lugs.
Before taking a reading from either gauge, configure the
Voltage Change-Over Board
(Figure 21) for the desired
output voltage.
Figure 21. Voltage Change-Over Board-
240/3
Ø Position
AC Voltmeter Gauge Reading
Place the
AC Voltmeter Change-Over Switch
(Figure 22)
in the W-U position and observe the phase to phase voltage
reading between the W and U terminals as indicated on
the
AC Voltmeter Gauge
(Figure 23).
X
Y
Z
O
U
U
1
2
V
V
2
1
W
W
2
1
JUMPER
6 PLACES
1
2
3
4
5
6
Figure 22. AC Voltmeter
Change-Over Switch
Figure 23. AC Voltmeter Gauge
(Volt reading on W-U Lug)
AC Ammeter Gauge Reading
Place the
AC Ammeter Change-Over Switch
(Figure 24)
in the U position and observe the current reading (load
drain) on the U terminal as indicated on the
AC Ammeter
Gauge
(Figure 25). This process can be repeated for
terminals V and W.
Figure 24. AC Ammeter
Change-Over Switch
Figure 25. AC Ammeter
(Amp reading on U Lug)
NOTICE
The
ammeter
gauge will only show a reading when
the
Output Terminal Lugs
are connected to a load
and in use.
