8
TROUBLESHOOTING (CONT.)
There is enough water in the
water tank, but the indicator to
“Add Water” stays on and the
unit will not function.
The water filter on the bottom of the
water tank may be blocked.
Remove the water filter and clean it.
________________________________
After following the procedure outlined in
#8 under the “Using your Icemaker”
section, if your icemaker still does not start
producing ice please try the following two
procedures:
1)
Follow the steps outlined in #8, then
wait approximately 5-10 minutes and
press the ‘Power’ button again.
2)
Unplug the unit’s power supply, wait
approximately 5-10 minutes, plug the
power supply back in, follow the steps
outlined in #8.
Ice cube sizes are inconsistent
The ice case panel may not be level.
Adjust the ice case panel and make sure it
is level.
There is not enough ice cubes in
the ice basket, but the indicator
of “ice full” is on.
The room temperature may be too
low, around 50°F.
___________________________
The ice cubes being formed may be
touching the sensor occasionally
when the ice case panel pushes the
ice cubes into the ice basket.
Make sure the unit is in an area where the
temperature is above 50°F regulated.
_______________________________
Remove the ice cubes; wait for a few
minutes to let the unit restart again.
Water not draining from the
water tank and “Add Water”
indicator light is on
Dirty water filter.
Remove the filter and clean it thoroughly.
ONLY USE WATER TO CLEAN THE FILTER.
(Refer to the “Cleaning the Water Filter”
section for further instructions.)
Humming or knocking sound
heard from the back side of the
unit.
Sound is normal and occurs as water
is being pumped from the water
tank.
Normal
PROBLEM
POSSIBLE CAUSE
SOLUTION
