background image

 
Page 2 of 11 

 

WARNING: FOR OUTDOOR USE ONLY 

 
 

FOR YOUR SAFETY 
Do not store or use gasoline or other 
flammable vapors and liquids in the vicinity of 
this or any other appliance. 

 

FOR YOUR SAFETY 
If you smell gas: 

1.  Shut off gas to the appliance. 
2.  Extinguish and open flame. 
3.  If odor continues, immediately call you 

gas supplier. 

CALIFORNIA PROPOSITION 65 – WARNING
Fuels used in gas or oil-fired appliance and 
the products of combustion of such fuels, 
contain chemicals known to the State of 
California to cause cancer, birth defects and 
other reproductive harm.  California Health & 
Safety Code Sec. 25249.6 

 

 

Safety Precautions: 

 

Care must be taken for the supervision of 
children in the vicinity of an operating or hot 
heater. 

 

Due to the high surface temperatures adults and 
children must observe clearances to avoid burns 
or clothing ignition. 

 

Check the heater thoroughly for damage.  DO 
NOT operate a damaged heater. 

 

The heater should be inspected before each use, 
and at least annually by a qualified service 
person. 

 

Do Not Modify the heater or operate a heater, 
which has been modified from its original 
condition. 

 

Do Not operate a heater that is not fully 
assembled. 

 

Use only with propane gas. 

 

Use only Vapor withdraw propane cylinder.  

 

Disconnect the propane cylinder from the heater 
when not in use. 

 

Never use the heater if the ballast weight is not 
assembled onto the base.  The base must be 
weighted to avoid tipping. 

 

Use only the regulator provided with the heater.  
Never connect heater to an unregulated gas 
supply. 

 

This heater is for outdoor use only; even so 
make sure that there is ample fresh air 
ventilation.  DO NOT use in buildings, garages, 
or other enclosed spaces. 

 

If at any time gas odor is detected, 
IMMEDIATELY DISCONTINUE operation until 
the source of gas has been located and 
corrected.  See Fuel Safety Precautions for 
more details about smelling odors.   

 

Install the heater such that it is not directly 
exposed to water spray, rain and or dripping 
water or wind. 

 

Always maintain minimum clearances to people 
or combustibles (like paper) of: Horizontal from 
dome (360

o

) – 3ft; Ceiling – 3ft. 

 

Operate only on a level stable surface. 

 

Do not move, handle or service while hot or 
burning. 

 

Do not use heater in a windy condition where 
wind speed exceeds 10 mph. 

 

Use only in accordance with local codes. 

 

Do not hang or attach clothing or any other 
combustibles from, on or near heater. 

 

Check control compartment burners and 
circulation air passageways for free air passage; 
make sure that there are no obstructions.  These 
areas are a common location for spider webs, 
which can present a dangerous condition, 
damage the heater and render it unsafe for use.  
The heater must be checked if any of the 
following conditions exist: 

a.  Gas smell along with predominate 

yellow tipping of the burner flames. 

b.  Heater does not reach temperature. 
c.  Uneven burner glow. 
d.  Burner makes popping noises during 

normal use, other than during shutdown. 

 

Only a qualified service person should install 
and repair this heater.  

 

Stainless steel emitter and gas valve should not 
be cleaned or painted.  The reflector and control 
cover may be cleaned with a non-corrosive / 
non-combustible solution, but not painted. 

 

After initial assembly and after every cylinder 
replacement, all gas connection should be 
checked for leaks with a soap and water solution, 
NEVER USE FLAME 

 

06/08 Rev A

Summary of Contents for MH40PH













Reviews: