Outdoor Patio Heater
5
Operating Instructions and Owner’s Manual
INTRODUCTION
The Mr. Heater patio heater is identified in Figure 1. The basic heaters
consist of the complete burner assembly, protection grid or glass,
reflector assembly, face guard, and mounting brackets.
MODEL MHRP37GL
FIGURE 1
WARNING: This heater is for outdoor or patio installation.
Not for used in residential dwellings.
•
Your heater comes fully assembled and is tested at the factory
with the appropriate type of gas and at the input pressures stated
on the nameplate.
•
Upon receipt and prior to attempting installation, be sure to
inspect the heater and its packaging for damage and/or missing
components. If damage is found or missing components are
suspected, contact your dealer.
•
Never attempt to operate the heater using a fuel other than that
specifically identified on the nameplate.
•
The installation of the heater must conform with all local building
codes or, in absence of governing local codes, with the National
Fuel Gas Code, ANSI Z223.1 (NFPA 54). This code can be
obtained from either the: Canadian Standards Association, 8501
East Pleasant Valley Road, Cleveland, OH 44131; or, NFPA, Battery
March Park, Quincy, MA 02269.
•
Canadian installations must comply with CAN/ CGA-B149.1.2 gas
code which can be purchased from Canadian Gas Association, 55
Scarsdale Road, Don Mills, Ontario M3B 2R3.
•
Contact factory when appliance is to be installed at high altitudes
(above 2000 ft). Factory can supply high altitude conversion kit
with instructions and data plate.
•
A plugged 1/8” N.P.T. Test Gage Connection is provided on the
heater gas control.
WARNING: Improper installation, adjustment, alteration,
service, or maintenance can cause property damage, injury,
or death. Read and understand the installation, operating,
and maintenance instructions thoroughly before installing or
servicing this equipment.
WARNING: This heater must be installed and serviced by
trained gas installation and authorized personnel only.
Inspect the heater annually. Failure to comply could result in
personal injury, asphyxiation, death, fire, and/or property
damage.
WARNING: Do not exceed 14” W.C. (34.87 mbar) inlet
pressure to heater.
A minimum clearance of 8’ above floor for public garages in
accordance with NFPA No. 88 most recent edition. Canadian
installations in public garages must comply with CGA 149B.1.9 most
recent edition.
WARNIN
G: A minimum clearance of 8’ above floor.
WARNING: Maintain clearances as shown on heater
nameplate.
