ERROR CODE
ERROR CODE
INSPECTION
Flashes “E0” – beeps and
shuts off after 10 seconds.
Either there is no cookware or no
compatible cookware placed on
unit.
Cookware may be too small or
too large for the electromagnetic
field.
Cookware is not centered on the
ceramic plate
Display “E1” without heating
Power supply voltage is below
90V+-10V. Retry after voltage
returns to normal
Display “E2” without heating
Power supply voltage is above
145V+-10V. Retry after voltage
returns to normal
Display “E3” without heating
Cookware is heated without any
food content.
Excess temperature of cookers
Temperature probe has short
circuit
Note: Retry after several minutes,
if error remains, contact
Sunpentown
Display “E4” without heating
Temperature probe is abnormal,
contact Sunpentown
Display “E5” without heating
High ambient temperature
Air inlet or air outlet is blocked
Fan is not working
Note: Retry after several minutes,
if error remains, contact
Sunpentown
Display “E6” without heating
Temperature probe is abnormal,
contact Sunpentown
Display “E7”
Furnace temperature sensor
error, contact Sunpentown
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a consumer ISM equipment, pursuant to Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver.
·
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
·
Consult the dealer or an experienced radio TV technician for help.
SSSSAVE
AVE
AVE
AVE THESE
THESE
THESE
THESE INSTRUSTIONS
INSTRUSTIONS
INSTRUSTIONS
INSTRUSTIONS
Additional safeguards
Do not operate appliance if the line cord shows any damage ,of if
appleance works intermittently of stops working entirely.
1. A short power-supply cord should be used to reduce the risk resulting
from becoming entangled in or trippoing over a longer cord.
2. Longer extension cord is used:
(1) The marked electrical rating ot the cord set of extension cord should
be at least as great as the electrical rating of the appliance ;
(2) The cord should be arranged so that it will not drape over the
countertop of tabletop where it can be pulled on by children or tripped
over unintertionally.
9
10
