Page 12
Servicing
Servicing
Safety regulations
Switch off machine and disconnect
electrical drive machines from mains
before servicing.
Never leave running machine unat-
tendedn.
Only use original “Mr. Paldu“ spare
parts.
Never work without guards.
Work on electrical equipment must
be carried out by qualified electricians.
Pressure plate guide
The pressure plate guide must be
greased at all times (apply grease with
brush).
Oil change
Caution!
Dispose of used oil in accor-
dance with environmental regulations.
Check legal environmental regulations.
Note:
Before changing oil, retract pres-
sure plate.
The first oil change should be carried
out after 50 operating hours and
further oil changes should also be
carried out every 50 operating hours
or at least once yearly.
• The oil drain plug is located at
the bottom of the oil tank.
When the oil-level gauge is full,
switch on machine and extend and
retract pressure plate two to three
times.
Then check oil level again and fill
up oil if necessary.
Total oil capacity of hydraulics system:
• 6 lt.
Suitable oil types:
Manufacturer
Type
dÉåçä
råáîÉêë~ä=ÖêÉ~ëÉ
cìÅÜë
råáîÉêë~ä=ÖêÉ~ëÉ=RMOU
Table 3: Suitable lubrication greases
Type
£js=eim=
jNM
^o^i
sáí~ã=
abNM
bic
eóÇêÉäÑ=
NM
dbkli
eim=NM
bppl
kìíç=eNM
s^isli
fkb
räíê~ã~ñ=
NM
pebii
qÉääìë=
qNM
qbu^`
l
oçåÇç=
eaJwNM
`^pqoli
eóëéáå=
^te=NM
cr`epL
_~ót~
oÉåçäáå=
_P
_m=
båÉêÖçä
pec=NM
Table 4: Suitable oil types
Summary of Contents for Horizontalspalter 550
