9 Visualization
Maschinenfabrik Reinhausen GmbH 2020
119
6385142/08 EN
ETOS
®
ED
Syslog standard
You can use this parameter to adjust the transmission process and the for-
mat for the syslog messages. You can select the following options:
Standard
Transport
Message format
RFC 5425 (recom-
mended)
TLS
RFC 5424
RFC 5426
UDP
RFC 6587
TCP
RFC 3164
UDP
RFC 3164
Table 24: Syslog standard
If you use the standard RFC 5245 (TLS), you have to import the root certifi-
cate and the client certificate with the corresponding key to the syslog
server. For more information, refer to the section titled Importing data
[
Syslog server
You can use this parameter to set the IP address of the syslog server.
Syslog server port
You can use this parameter to set the port of the syslog server.
Reconnect delay time
You can use this parameter to determine how long the device will wait be-
fore it attempts to reconnect after the connection has been interrupted earlier
or a syslog message could not be transmitted (only for TCP or TLS).
Device designation
You can use this parameter to set the device designation that the device will
be identified with on the syslog server.
Severity level
You can set which syslog messages the device will send. You can also acti-
vate or deactivate messages for each severity level.
Severity level
Description
Emergency
The system is unusable.
Alert
Immediate intervention required.
Critical
Critical state
Error
Error state
Warning
Warning state