9 Visualization
Maschinenfabrik Reinhausen GmbH 2020
285
6385142/08 EN
ETOS
®
ED
Adding a sensor
If you would like to add a sensor, then you have to set the Modbus address,
sensor name and version. In addition, you can select whether the device is
to perform an automatic function assignment of the data points.
Proceed as follows to add a sensor:
1. Go to
Settings > Sensor bus > Sensor management
.
2. Press the
New sensor
button.
Figure 211: Add sensor
3. Enter the
Modbus address
or press the
Next free address
button.
4. Select the
Sensor name
.
5. Select the
Version
.
6. If necessary, enable the
Assign functions
option.
7. Press the
Accept
button.
8. After adding a sensor or several sensors, restart the device to apply the
changes.
Before restarting the device, you can add even more sensors or change ad-
ditional settings such as the function assignment or configuration of analog
or digital inputs.
Removing a sensor
Proceed as follows to delete a sensor:
1. Go to
Settings > Manage sensor
.
2. Press the
button to delete the sensor.