9 Visualization
Maschinenfabrik Reinhausen GmbH 2020
294
6385142/08 EN
ETOS
®
ED
Property
Options
Minimum/maximum
value
2)
Set the minimum and maximum values of the sensor, e.g.
with a 4...20 mA signal, the corresponding measured
value for 4 mA and the corresponding value for 20 mA.
Correction factor
3)
Set the correction factor (m) for the correction of the func-
tion value (x). The corrected function value (y) is:
y = (m * x) + t
Correction offset
3)
Set the offset (t) for the correction of the function value
(x). The corrected function value (y) is: y = (m * x) + t
Table 89: Configuration of the analog inputs and outputs
1)
Only available for GPAI.
2)
Not available with sensors connected over the MR sensor bus (Modbus).
3)
Only available for inputs.
Figure 221: Configuring analog inputs/outputs
You can only change the configuration of the analog inputs and outputs if
you have a Parameter Configurator or Administrator role.
When in delivery status, you can log in as the administrator as follows:
▪ User name:
admin
▪ Password:
admin
Creating a backup
You need to create a backup to be able to reset the system in the event that
any incorrect configuration settings are made. To do so, proceed as follows:
1. Go to
Settings > Export
.
2. Go to the option
Settings
to export a backup copy of the current settings.
3. Select the desired
Interface
(USB or PC).