Recirculating cooler
（
Chiller
）
13
communication control . press
and
to modify setting value, press
Left-shift key
to move the input location, press Enter key
to
save current setting and enter into next parameter set process, press
to quit current setting and back to the work interface, press Menu key
to quit without saving setting value and enter into next parameter set
interface.
3.3.2 The second interface : the auxiliary display shows ‘R_CM’, is temperature
control mode,‘1’ for Start/Stop control mode, ‘2’ for high precision temperature
control mode;setting method same as above.
3.3.3 The third interface : the auxiliary display shows ‘R_CS’, the main display
show temperature control setting parameter, ‘0’ for set mode, ‘1’ for tracking
mode. Press Menu key
to enter into next interface,press
and
to modify the parameters.
3.3.4 The fourth interface: the auxiliary display shows ‘R_MS’, the main display
shows the option of the main sensor port, ‘1’ for sensor port one, ‘2’ for sensor
port two and ‘3’ for sensor port three; setting method same as above.
3.3.5 The fifth interface: the auxiliary display shows‘R_SS’ , the main display
shows the port option of the auxiliary sensor; the revise method same as
Start automatic control, cooling mode will automatically start once
power on;stop automatic control, if turn off the automatic control,
cooling control can be restart by pressing Start/Stop key
.
