9
4.5 Operating unit
(3)
(1)
(2)
(4)
(5)
(6)
(1)
[mem.clr./all] key
: Key to put “*” mark to identify data when data is output externally. When
pressed for more than 2 seconds, all data can be cleared.
Also this key shifts the cursor to the left for numerical entry.
(2)
[+/
α
] key:
Key to move the cursor upward on selection. It selects temperature
compensation coefficient
α
by pressing for more than 2 seconds. This key
also increments a number for numerical entry.
(3)
[mem.out/all] key:
Key to output data externally. By pressing for more than 2 seconds, all data
or certain data can be output. This key also moves the cursor to the right in
numerical entry.
(4)
[-/cal] key:
Key to shift the cursor downward on selection. Pressing for more than 2
seconds turns the mode to calibration. This key also decrements a number on
numerical entry.
(5)
[ok/meas.] key:
Key to start measurement or hold data on measuring screen.
When pressed with [esc] key at the same time, it turns the mode to Function.
This key also confirms the selection or numerical entry. This key stores the
measurement data when Memory in is set at Manu and the data is held. This
key executes data clear or data output.
(6)
[esc/on/off] key:
Key to return the screen from Function to Measurement. This key also turns
on the unit when pressed for more than 2 seconds while the unit is off, and
turns it off when the unit is on.
