10
5. Preparation for measurement by DA-130N
5.1 Loading the battery
Set the dry cells in the battery holder. Use alkaline dry cells (size “AAA”). Insert the cell while paying
attention to the polarity direction. Remove the battery cover by pulling it out.
Slide in the battery holder all the way to the end, and put on the cover.
•
Insert to see the flat bottom touch the spring.
•
Press [On/Off] to check the display. If display does not appear, check the battery
direction.
•
When replace the battery, change all of the cell at the same time.
•
Always use the same type of dry cell.
(Note) Do not use other dry cell than alkaline “AAA” type, e.g. NiCd dry cell
Press [On/Off] key for more than 2 seconds to turn on the power.
The below initial screen will appear and when it changes to measuring screen, the unit is working in
normal condition.
Initial screen
Measuring screen (above is an example)
The battery capacity can be checked on the measuring screen.
: Enough energy is stored
(Level 3)
: It is running down.
(Level 2)
: Almost no more energy.
(Level 1)
: Change the battery.
(Level 0)
* the alarm will sound.
•
The above capacity level is just for as a guide.
•
Beep sounds only when the power is turned on.
+
−
+
−
