27
9.4 Display of measurement data and external output
You can recall the stored measurement data on display again, or output to the optional printer or PC.
•
How to recall a measurement data on display
1.
Press [mem.out] key to blink the sample number on upper right corner.
Here it blinks
2.
Change the sample number with [
+
], [
−
] key, and you can recall the stored data of specific
sample number.
•
How to output single sample measurement data
1.
While a data is shown on display with [mem.out] key pressed, press [ok/meas.] key to blink
symbol and print out or output to PC.
•
How to output a series of sample measurements or all of the data
1.
With [mem.out] key pressed for more than 2 seconds, the message ‘Memory Out’, Execute? (All)
will appear at the upper-left corner on the display.
2.
Select “All” and press [ok/meas.] key to blink , and all the stored data will be printed out or
output to PC.
3.
After the data are output, the below message will be prompted asking whether to erase or not. If
you want to erase it, choose “Yes” and execute with [ok/meas.] key.
4. If you output a series of sample measurements, select “Range” and press [ok/meas.] key, the range
where you can make entry will appear as shown below. After entering the data that you want to
output, execute with [ok/meas.] key.
ok
After the output is completed, the display will return to the initial screen display (meas. mode).
