background image

1

  Safety notes 

·

  Transport the equipment with care!

·

  Careful transportation of the equipment requested !

· 

The unit may NEVER be overturned nor put upside down !

· 

Equipment and its internal parts can be damaged :

- by dropping
- by shock.

·

  Do not start up the equipment if Equipment should only be operated by

properly instructed personnel ! 

- it is damaged or leaking
- the supply cable is damaged.

·

Switch off the equipment and pull out the mains plug for:

- servicing or repair

- before moving the equipment!

·

Have  the  equipment  serviced  or  repaired  only  by  properly  qualified

personnel ! 

· 

At low temperatures, do not move or bend    the insulated flex line tube !

·

  Be careful not to bend the insulated flex line appreciably after the unit has

chilled down the probe and line. 

·

  The flexible line to the cold probe should have no sharp bends nor signs

of broken tubing. 

2

 

Unpacking 

Goods are packed carefully, largely preventing transport damage. 
After  unpacking  ,  check  first  the  equipment  and  accessories  for  possible 

transport damage. If unexpectedly any damage can be noticed on the equipment it is 
essential to notify the forwarding agent or the postal authorities so that an inspection 
can take place. 

Do not start operations with damaged equipments! 
The unit may NEVER be overturned nor put upside down ! 

3

  Equipment description

 

Refrigeration unit 

The refrigeration unit consists essentially of a fully sealed compressor. The Cryocoil 
or Cryoprobe is cooled down to a very low temperatures,through a flexible heat 
exchanging tube located on the top of this equipment. Heat of condensation and 
motor heat are dissipated on air-cooled units through a fan-cooled ribbed condenser. 

Summary of Contents for FIGR-100









Reviews: