Bolt Junior Quick Start Guide
14
5.1 In the Windows Taskbar, right-click the INtime icon.
5.2 Select
Restart NodeA
.
6.
On the Flair PC, start the Flair application by double-clicking on the
Flair icon on the Desktop.
Flair automatically loads the relevant firmware into all attached axis
boards, including:
The quad board that runs the track motor The Ulti-box that is
mounted on the Bolt Junior arm
Any additional interface boxes that are attached to the
computer stack
7.
Release the E-stop that is plugged into
the computer stack, by turning the
button clockwise until the red button
pops up and then pressing the Reset
button. Also make sure the key is in
the vertical position. The horizontal
position of the key bypasses E-stop
from Hand Held box and Flair.
Therefore, the key should
not
be kept
in horizontal position when using Bolt
Junior except for testing purposes.
Once all E-stop buttons on the system are up, the Stäubli CS8 display
shows “
U
”.
Reset button
Key
Summary of Contents for Bolt Junior
