Broadcast Talos Quick Start Guide
11
Attaching the track motor pinch wheel to Talos
1.
On the separately supplied pinch wheel assembly, remove the brass
retaining pin by pulling on the ring.
2.
Mount the pinch wheel assembly onto the track motor on the Talos
underside, by sliding the track motor gear against the rack and
putting the pinch wheel Socket onto the track motor Mounting bar.
3.
Push the track motor slightly towards the rail racking so that the
track motor gear is in mesh with the rack.
4.
Replace the retaining pin in the pinch wheel assembly by pushing on
the ring (not the sleeve), to hold the assembly in place on the track
motor.
Mounting bar
Socket
3
Anti skip block
