Broadcast Talos Quick Start Guide
13
Removing the trolley wheels
If you mount Talos onto a track or permanent base then you can remove
the two trolley wheel units that are on either side of the Talos base.
1.
With the base of Talos supported by the track or other base mount,
turn the crank on each end of the wheel unit so that the wheels are
suspended in the air, just above the ground.
2.
Lift the wheel unit slightly to take the stress off the brass retaining
pins, and pull out the retaining pin at each end of the wheel unit.
Top view
Oblique view
Retaining pin
