Studiobot TX90 Quick Start Guide
37
The LAN addresses of the MRMC devices are
static
. That is, they will
stay the same unless you explicitly change them.
Changing the IP Address of the Network Devices
The system will work ONLY if ALL IP addresses are in the same subnet,
including the destination IP addresses.There are potentially the following
IP addresses involved:
1.
The IP address of the Flair PC.
You don’t ordinarily need to change
this unless you are connecting it to a local network that requires
different settings.
2.
The IP addresses of the nodes in NetworkDirect
. These are the IP
address of the nodes in Flair such as the Unibox for lens motors and
the Quad board in the track.
3.
The IP address of the FreeD box.
This is IP address that can be
changed using Tera Term.
Flair PC
The default IP address of the Flair PC is 192.167.1.10. This is set in the
INtime configuration.
To change this IP address:
Hint
Most local networks use the SN and GW values shown in the above
table, so under ordinary circumstances you will only need to be
concerned with
IP addresses
. The rest of this section therefore
concentrates on
IP addresses
, but you might also need to inspect or
change the SN and GW addresses, depending on the structure of the
network that you are using to access the head.
Summary of Contents for MRMC-2000-00-JB-0053
